How to adjust the cyclone state

Cyclone working condition is normal, what is the judgment standard and debugging method, the overflow concentration and fineness to meet the next process conditions, but also need to first meet the conditions, the following describes how to adjust the cyclone state.

Cyclone overflow concentration is small, fine fineness. At this time, the cyclone needs to reduce the pressure or adjust the concentration of ore, but also by replacing the small sand sink mouth to meet the requirements; overflow concentration is large, the fineness of coarse. Cyclone manufacturer introduces this cyclone can increase the pressure and adjust the concentration of the feed, but also by replacing the large sand sinker to meet the requirements. Cyclone manufacturer suggests but the above adjustment can not just rely on a way to adjust, because this may make the cyclone work is not normal and stable.

Cyclone manufacturer suggests that if the cyclone sinker sand scattering angle is too large, there are three reasons: the sand sinker nozzle is too large, and the sand sinker concentration is too low. At this time, you can adjust the cyclone by replacing the small sand sinker; the feed pressure is too small, you should adjust the pump feed pressure to meet the process conditions; the feed volume is too small and the concentration of the feed is too low. At this time, you can adjust the size of the cyclone ore feed and the number of cyclone open units. In short, the cyclone manufacturer explained that the size of the cyclone sand concentration, directly affect the efficiency of the mill, affect the size of the discharge, the entire cyclone process will have an impact.